97710 Boost Tube System for 2017 thru 2019 L5P
Installation manual 97710 for Boost Tube System for 2017-2019 Chevy/GMC 2500/3500 6.6L Duramax, L5P. Part Number 25999.
June 25, 2021
96512 Monster Exhaust for 1987-2001 Jeep Cherokee
Bill of Materials General Installation Practices Installation Instructions 1. Disconnect the negative (ground) cable from the battery (if there is more than one battery, disconnect both negative
June 23, 2021
96433 Revolver® Exhaust Header with Hardware for 1991-1999 Jeep Wrangler 4.0L, 1991-1998 Cherokee
General Installation Practices Bill of Materials Exhaust Manifold Installation NOTE: Do not wrap manifold. Wrapping the Revolver Manifold with exhaust wrap or thermo tape will void the
June 21, 2021
96434 Torque Tube System for Jeep 4.0L
Bill of Materials General Installation Practices Tools Required: • 1⁄4” and 3⁄8” drive ratchets with inch and metric sockets and 3⁄8” drive extension • Inch and metric
June 21, 2021
97675 Monster Exhaust 5″ System for 2017-19 & 2020-2023 Chevy/GMC 6.6L L5P Duramax
Bill of Materials Note: 20+ DRW Models have a 2-piece Rear Tailpipe section for extra clearance around the wheel wells. General Installation Practices Monster Exhaust System Installation
June 17, 2021
96425 Monster-Ram Intake with Banks Boost Tube for 2003-07 Dodge 5.9L Cummins
General Installation Practices Special Note: Boost-Tube clamp placement and alignment Stock Intake Elbow and Boost Tube Removal 1. Loosen the clamps that hold the rubber hose at
June 15, 2021
97696 Banks PedalMonster with iDash and Derringer
2. Connect the 6-Pin Female Banks Bus cable (supplied with the kit) from the PedalMonster module to the iDash. 3. Connect the OBD-II Cable from the vehicle’s
June 8, 2021
97696 Banks PedalMonster with iDash Configuration
Note: If you do not have an iDash and will be using the PedalMonster in a standalone configuration, go to Section 4 on the PedalMonster installation home
June 7, 2021
97696 Banks PedalMonster with Derringer and Switch Configuration
For those with an existing Derringer tuner with a 3-position power level switch, you will need an OBD splitter. Follow the instructions for PedalMonster Stand-Alone kit for
June 7, 2021
97696 Banks PedalMonster – Stand-Alone Configuration
Section 1: Beginning Installation 2. Locate the connector at the top of the accelerator pedal. While some connectors face the driver, others may face up toward the
June 7, 2021