The Leader in Diesel Performance
General Assembly NOTES: Sensor adapter and removable 1/8″ NPT sensor plug is pre-installed. Remove plug and replace with your choice of sensor prior to installation. Small O-ring
Special Note: Boost-Tube Clamp Placement and Alignment Bill Of Materials Section 1: Preparing for Installation 1. Secure the truck on a lift and remove both front wheels
The video install above shows an install on a 2012-2016 Duramax 6.6L. While the 2011 model year features a two-piece hot-side boost tube, the installation process is
Removal Locate MAF Sensor Found on the intake tube near the airbox. Remove sensor plug Slide out red locking pin. It will only slide out about 1/8″.
General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Disconnect the negative (ground) cable from the
General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Disconnect the negative (ground) cable from the
How to install, set up, and configure the Banks PedalMonster throttle controller. For use with all stand-alone, and iDash confiura
General Installation Practices Disclaimers Section 1: Installation of Wire Harness and Derringer Tuner Derringer Tuner System Configuration 1.1 Derringer Tuner System Configuration 1.2 Derringer Sensor Harness Installation
General Assembly Bill of Materials Note: 2024+ Jeep 4xe kits use an updated intake tube, vacuum tube mounts, and turbo inlet. Install steps have been updated to