The Leader in Diesel Performance
Table of Contents Disclaimer of Liability and Warranty End User License Agreement (EULA) Section 1: SAFETY PRECAUTIONS Section 2: Mounting and Connection iDash Section 3: Software Introduction
Section 2: Mounting and Connection iDash If installing into vehicle with OBDII communication (standard): 1. Locate the OBDII port in your vehicle. The OBDII port is located
Section 1: Safety Precautions Always observe safety precautions! Gale Banks Engineering urges you to always follow safety precautions. Be sure to carefully read and understand each precaution
Important! Please READ! This End-User License Agreement (“EULA”) is a legal agreement between you (either an individual or a single entity) later referred to as “LICENSEE” and
Disclaimer of Liability and Warranty Gale Banks Engineering Inc., and its distributors, employees, and dealers (hereafter “SELLER”) shall in no way be responsible for the product’s proper
This install guide references the Single Heat Monster-Ram. For Dual-Heat Capable Monster-Ram Installs, please use the updated guides below. 2007.5-2012 2013-2018 (Single Heat) Monster-Ram w/Intake Plate Install
FITMENT ALERT: Dana M275 General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Disconnect the negative
General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. The exploded views provide only general guidance.
General Assembly NOTES: Sensor adapter and removable 1/8″ NPT sensor plug is pre-installed. Remove plug and replace with your choice of sensor prior to installation. Small O-ring
Special Note: Boost-Tube Clamp Placement and Alignment Bill Of Materials Section 1: Preparing for Installation 1. Secure the truck on a lift and remove both front wheels