9777X | Banks Engine Cover for 2007.5-2024 RAM 2500/3500 6.7L Diesel

1. Pinch the rubber gromets to install them into the engine cover.

2. Then slide the steel sleve into the grommet.

3. Repeat for the remaining 3 mounting postitions.

1. Use the supplied T30 Torx bit to remove the top screw on the Monster-Ram EGR heat-shield.

2. Be sure to remove both the screw and the spacer underneath.

4. Remove the EGR heat-shield from the Monster-Ram.

5. Apply a small drop of the included threadlocker to the threads, then retorque the two bolts to 18-20 ft-lbs.

1. To install the front support bracket, you will have to temporarily remove all 8 bolts and studs from the valve cover.

The front 6 bolts are easy to get to, the rear two will require either a wobble socket or an 8mm wrench.

2. Start removing the front valve cover bolts and set them aside.

3. Move the rear engine harness off the studs to expose the rear bolts.

4. Depending on the year of your truck, some of the bolts may include studs, and will require a deep 8mm socket.

5. Continue removing the bolts that hold the rear of the valve cover on.

6. For the rear two bolt/studs, a wobble socket or a wrench is needed to provide adequate clearance.

7. Remove the two rear bolts/studs and set them aside.

8. Remove the oil cap.

9. Grab the front bracket for the Banks Engine Cover.

10. Pre-insert two small 10mm cap head torx screws with washers.

11. Start threading the torx screw in by hand.

12. Then secure it in place with the provided T30 torx bit.

13. Reinstall the oil cap while you line the valve cover back in place.

13. Apply some blue lock tight on two of the longer 30mm button head cap screw,.

14. Preinstall the 30mm screws with washers into the driver side bracket.

15. Line up the bracket over the second and third-to-last holes in the valve cover on the driver’s side, and start tightening them by hand.

16. Tighten the driver side bracket down with the supplied T30 torx bit.

17. Continue to reinstall the remaining factory bolts for the valve cover

18. Use your wobble socket or wrench for the rear two bolts, and reattach the engine harness to the studs.

19. Snug down all 8 valve cover bolts/studs.

1. Bring the Banks Engine Cover over the engine.

2. Apply a drop of blue threadlocker onto a 30mm button head torx screw.

3. Carefully thread in the t30 screw and washer into the passenger side. Don’t fully snug the bolt down yet.

4. Continue onto the other 3 locations with the 20mm Torx screws.

5. The last 10mm torx screw threads in on the back side, near the Monster-Ram.

6. Snug it down with the supplied T30 torx bit. Then snug down the remaining torx screws.

7. Don’t forget to install your new Banks Revolver Oil Cap to complete your installation.