Required Tools: Ratchet Extension13MM Socket10MM SocketT20 TorxFlathead Screwdriver What’s Included: If something is missing, call 800-601-8072 immediately! Section 1: Removing Stock Intake 1. With a 10mm socket, loosen and remove the negative terminal on both batteries. 2. To remove the Mass Air Flow Sensor, slide back the red locking tab. Then, press down with your […]
General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Disconnect the negative (ground) cable from the battery (or batteries, if there are two) before beginning work. 3. When raising the vehicle, support it on properly weight-rated safety stands, ramps, or a commercial hoist. Follow […]
NOTE: When removing the stock hardware, such as the hanger and assemblies, it is helpful to soak these parts with a spray lubricant, so you may want to add that to your set although it is not required Section 1: Removing Stock Exhaust System 1. Secure the Jeep on a lift. 2. Loosen the driver-side […]
Installation instructions for Banks Ram-Air Cold Air Intake System for 2019-2024 Ram 2500/3500 6.7L Cummins
Installation manual 97710 for Boost Tube System for 2017-2019 Chevy/GMC 2500/3500 6.6L Duramax, L5P. Part Number 25999.
Bill of Materials Use caution when working in the engine compartment. Make sure the engine has been OFF for several hours and cool. Some components from the stock air intake system will remain in service. Take caution when removing stock components. Tools Required: 8mm or 5/16″ nut driver or flat end screwdriverPhilips screw driver10mm socket […]
This install guide references the Single Heat Monster-Ram. For Dual-Heat Capable Monster-Ram Installs, please use the updated guides below. 2007.5-2012 2013-2018 (Single Heat) Monster-Ram w/Intake Plate Install Video Note: The billet heater plate, Item #22, is transitioning to a cast design (42731) with integrated fuel rail spacers. If your kit ships with this cast heater […]
FITMENT ALERT: Dana M275 General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Disconnect the negative (ground) cable from the battery (or batteries, if there are two) before beginning work. 3. When raising the vehicle, support it on properly weight-rated safety stands, ramps, or […]
General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. The exploded views provide only general guidance. Refer to each step and section diagram in this manual for proper instruction. 3. Throughout this manual, the left side of the vehicle refers to the driver’s side […]
Special Note: Boost-Tube Clamp Placement and Alignment Bill Of Materials Section 1: Preparing for Installation 1. Secure the truck on a lift and remove both front wheels to allow for full access. To remove the fender well, you will need a T-15 Torx bit. 2. Remove both of the front fender liners. Section 1: Removal […]