The video install above shows an install on a 2012-2016 Duramax 6.6L. While the 2011 model year features a two-piece hot-side boost tube, the installation process is the same otherwise. General Installation Practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. Throughout this manual, the left […]
Removal Locate MAF Sensor Found on the intake tube near the airbox. Remove sensor plug Slide out red locking pin. It will only slide out about 1/8″. Sliding this pin back will allow you to depress the button just in front of it. While pushing button, push the plug in as if you were connecting […]
General Installation Practices Disclaimers Section 1: Installation of Wire Harness and Derringer Tuner Derringer Tuner System Configuration 1.1 Derringer Tuner System Configuration 1.2 Derringer Sensor Harness Installation WARNING: Ensure the engine bay is cool. Remove keys from the ignition. Disconnect the battery GROUND (-) cables. Secure the cables so that they do not come in contact […]
General Assembly Bill of Materials Note: 2024+ Jeep 4xe kits use an updated intake tube, vacuum tube mounts, and turbo inlet. Install steps have been updated to reflect these minor changes. Section 2: Removal of the factory intake system 1. Remove the IAT sensor. Pull the locking clip towards you and twist counter-clockwise about 45 […]