Ram-Air

Section 1: General Assembly Bill of Materials Tools Required: 10mm Socket5/16″ SocketRatchet Extension1/4″ RatchetPhilips Screw Driver​​​​​​​Flat Head Screw Driver Recommended:Plastic Panel Popper Tool5/16″ Nut Driver Section 2: Stock Intake Tube Removal Use caution when working in the engine compartment. Make sure the engine has been OFF for several hours and cool. Some components from the stock […]

Section 1: General Assembly Bill of Materials Tools Required: 8mm SocketRatchet ExtensionPhilips Screw Driver​​​​​​​T20 Torx Screwdriver Section 2: Old Ram-Air Intake Tube Removal Use caution when working in the engine compartment. Make sure the engine has been OFF for several hours and cool. Some components from the stock air intake system will remain in service. 1. […]

Bill of Materials General Installation Practices Stock Hot Side Removal 1. With a 12mm socket, remove the negative lead from the battery. 2. Next, locate the airbox. 3. Unplug the Mass Air Flow sensor. 4. Remove the two screws holding the MAF sensor in place. Set the MAF sensor aside for now; it will be […]

41849 Banks Ram-Air Intake for 2020-2022 Ford F250/F350/F450/ 6.7L Power Stroke

Required Tools: Ratchet Extension13MM Socket10MM SocketT20 TorxFlathead Screwdriver What’s Included: If something is missing, call 800-601-8072 immediately! Section 1: Removing Stock Intake 1. With a 10mm socket, loosen and remove the negative terminal on both batteries.  2. To remove the Mass Air Flow Sensor, slide back the red locking tab. Then, press down with your […]

Installation instructions for Banks Ram-Air Cold Air Intake System for 2019-2024 Ram 2500/3500 6.7L Cummins

Tools Required: 1. 3/8″ drive ratchets with metric sockets2. Standard and Phillips head screwdriver3. Standard and needle-nose pliers4. Clean shop towels or rags5. 5/16″ nut driver6. T-30 driver General Assembly Bill of Materials Ram-Air Installation 1. Remove the bolt, using a 13mm socket, from the radiator core support that secures the factory air housing and […]

Bill of Materials Use caution when working in the engine compartment. Make sure the engine has been OFF for several hours and cool. Some components from the stock air intake system will remain in service. Take caution when removing stock components. Tools Required: 8mm or 5/16″ nut driver or flat end screwdriverPhilips screw driver10mm socket […]

General Installation Practices Bill of Materials General Assembly Section 1: Stock Intake Removal Read and follow all steps before working on the vehicle. Some components from the stock air intake system will remain in service. Take care when removing stock air intake components to not damage them. Use the Bill of Materials Chart and the […]

Removal Locate MAF Sensor Found on the intake tube near the airbox. Remove sensor plug Slide out red locking pin. It will only slide out about 1/8″. Sliding this pin back will allow you to depress the button just in front of it. While pushing button, push the plug in as if you were connecting […]