Boost Tubes

Bill of Materials ATTENTION: Boost-Tube & Billet Couplers When installing the boost tubes to the billet couplers, first be sure the bead of the tube clears just into the hump section of the hose. Then pull back about a quarter inch so that the bead is now securely pressed into the inside of the hose […]

This Banks Boost Tube upgrade kit for Ford Super Duty covers 2011-2026 model years. While the install steps are identical across this year range, the parts in your kit will vary slightly between 2011-2016, 2017-2026, and High Output models. Use the Bill of Materials list below to verify the parts included in your kit. If […]

Bill Of Materials Section 1: Preparing for Installation 1. Secure the truck on a lift and remove both front wheels to allow for full access. To remove the fender well, you will need a T-15 Torx bit. 2. Remove both of the front fender liners. Section 1: Removal of the OEM hot side tube 1. […]

ATTENTION: Boost-Tube Clamps When installing the clamps, be sure the hose and clamps go on far enough to clear the bead on each end, about 1.25 inches. An improper installation, such as a clamp sitting directly on a bead or crossed diagonally, will result in a boost leak. Bill of Materials Removing Stock Boost Tubes […]

Installation manual 97710 for Boost Tube System for 2017-2019 Chevy/GMC 2500/3500 6.6L Duramax, L5P. Part Number 25999.

General Installation Practices Special Note: Boost-Tube clamp placement and alignment Stock Intake Elbow and Boost Tube Removal 1. Loosen the clamps that hold the rubber hose at the inlet of the stock intake elbow and slide the hose free of the intake inlet.  CAUTION: Cover the intercooler up-pipe opening with a clean rag to prevent […]

Special Note: Boost-Tube Clamp Placement and Alignment Bill Of Materials Section 1: Preparing for Installation 1. Secure the truck on a lift and remove both front wheels to allow for full access. To remove the fender well, you will need a T-15 Torx bit. 2. Remove both of the front fender liners. Section 1: Removal […]