Toyota

Bill of Materials General Installation Practices Stock Hot Side Removal 1. With a 12mm socket, remove the negative lead from the battery. 2. Next, locate the airbox. 3. Unplug the Mass Air Flow sensor. 4. Remove the two screws holding the MAF sensor in place. Set the MAF sensor aside for now; it will be […]

Bill of Materials ATTENTION: Boost-Tube & Billet Couplers When installing the boost tubes to the billet couplers, first be sure the bead of the tube clears just into the hump section of the hose. Then pull back about a quarter inch so that the bead is now securely pressed into the inside of the hose […]

Part Number 63389 Fits the A-Pillar below found in the:• 2005-2015 Toyota Tacoma Installation Guide Note: If you’ve chosen to paint the pods yourself, please visit bankspower.com/paint to get perfectly matched spray paint. No primer is needed just three to four light coats. What’s Included • iDash Stealth Pod•A Step Bit• A Hex Screw• Washer• […]

iDash Stealth Pod install guide
for 2014-2021 Toyota Tundras without a factory grab handle.

Part Number 63373 & 63376 Fits the A-Pillar below found in the:• 2022-2024 Toyota Tundra Installation Guide Note: If you’ve chosen to paint the pods yourself, please visit bankspower.com/paint to get perfectly matched spray paint. No primer is needed just three to four light coats. What’s Included • iDash Stealth Pod • A Step Bit […]

Part Number 63372 Fits the A-Pillar below found in the:• 2016-2023 Toyota Tacoma Installation Guide Note: If you’ve chosen to paint the pods yourself, please visit bankspower.com/paint to get perfectly matched spray paint. No primer is needed just three to four light coats. What’s Included • iDash Stealth Pod• A Step Bit• A Hex Screw• […]